TEL:186-1567-9770

Home > News
What is the reason for the frequent heating of the fully automatic CNC Nesting Router?
Last Modify:2025-07-10 14:51:12
  During the use of the CNC Nesting Router, it was found that some machines heated up during operation. In this case, it is necessary to restart the equipment. Check whether the machine is equipped with a thermal reset button, which can show in detail whether the indicated temperature is higher than the safe operating level. In addition, the infrared camera can also show when the standard temperature is exceeded.
How to prevent the cutting machine from overheating and causing failures?
CNC Nesting Router
1. Perfect daily maintenance can ensure that various components in the automatic system of the cutting machine are supervised, thereby minimizing overwork and overheating.
2. Installing smart sensors can promptly remind technicians of problems and solve the heating problem of the machine in a timely manner.
3. The CNC Nesting Router is equipped with an overload protector to prevent load problems in the furniture cutting machine and directly solve damage to the machine head.
2. Causes of overheating:
1. The voltage of the CNC Nesting Router is too high or it is overworked, resulting in electrical overload, which causes the machine to overheat. When the cutting machine cannot operate or there is an abnormal load, heat will become the main side effect, causing the machine to fail.
2. Low resistance is also a common cause of failure of CNC Nesting Routers. By reducing the motor windings by heating, the machine will short-circuit and leak, which will cause the equipment to face a greater risk of failure.
3. Dust and debris pollution will cause the internal temperature of the cutting machine to prevent cooling, resulting in long-term overheating of the machine. This is mainly due to the lack of proper maintenance or the failure to clean up the pollutant particles in time.
4. The start-stop frequency can play a vital role in thermal damage. Excessive starting, stopping and restarting of the machine will not cause normal cooling. Therefore, high temperature environment will cause component wear.
5. The impact of vibration will change from small to large, causing the machine to overheat. If the vibration is very severe, the temperature will rise and the normal efficiency of the machine will begin to decline.
Once the fully automatic CNC Nesting Router starts to heat up, you can check the above reasons. Generally, when using the equipment, you must perform maintenance and inspection in time. Only in this way can you better guarantee the service life and production efficiency of the equipment.